Design and Fabrication of PVA-SnO2 Based Humidity Sensors

Authors

  • I Dewa Putu Hermida National Research and Innovation Agency, Gedung B.J. Habibie, Jl. M.H Thamrin No. 8, Jakarta Pusat-10340
  • Asrul Izam Azmi Universiti Teknologi Malaysia
  • Sevia Mahdaliza Idrus Universiti Teknologi Malaysia
  • Goib Wiranto National Research and Innovation Agency, Gedung B.J. Habibie, Jl. M.H Thamrin No. 8, Jakarta Pusat-10340
  • Robeth V. Manurung National Research and Innovation Agency, Gedung B.J. Habibie, Jl. M.H Thamrin No. 8, Jakarta Pusat-10340
  • Nurul Hasanah National Research and Innovation Agency, Gedung B.J. Habibie, Jl. M.H Thamrin No. 8, Jakarta Pusat-10340
  • Mustofa Amirullah National Research and Innovation Agency, Gedung B.J. Habibie, Jl. M.H Thamrin No. 8, Jakarta Pusat-10340
  • Annida Rahmawati National Research and Innovation Agency, Gedung B.J. Habibie, Jl. M.H Thamrin No. 8, Jakarta Pusat-10340
  • Papat Hidayatullah National Research and Innovation Agency, Gedung B.J. Habibie, Jl. M.H Thamrin No. 8, Jakarta Pusat-10340

DOI:

https://doi.org/10.11113/elektrika.v22n1.419

Abstract

In this research, humidity sensors based on Polyvinyl Alcohol (PVA)-Tin Oxide (SnO2) have been designed and fabricated using screen printing. The sensor devices were fabricated on Alumina Substrate (Al2O3) with Silver (Ag) as the electrode material. The number of fingers on the electrodes was varied to obtain different sensor resistance values. SnO2 was added to the PVA sensing layer with variations in the composition. The size of granules formed from mixing PVA-SnO2 material will also be observed.

Downloads

Published

2023-04-28

How to Cite

Hermida, I. D. P., Azmi, A. I., Idrus, S. M., Wiranto, G., Manurung, R. V., Hasanah, N., … Hidayatullah, P. (2023). Design and Fabrication of PVA-SnO2 Based Humidity Sensors. ELEKTRIKA- Journal of Electrical Engineering, 22(1), 1–5. https://doi.org/10.11113/elektrika.v22n1.419

Issue

Section

Articles